Dimensional and morphologic characteristics of unilateral impacted maxillary central incisors.

INTRODUCTION: This cross-sectional study aimed to investigate the crown and root characteristics of impacted central incisors compared with spontaneously erupted contralateral incisors and the influence of etiologic and local factors on their dimensions. METHODS: Forty-five patients (22 boys, 23 girls) who underwent orthodontic treatment for unilateral impaction of maxillary central incisors were referred for cone-beam imaging. Dimensions of the impacted and contralateral incisors were assessed using Dolphin 3D software (Dolphin Imaging & Management Solutions, Chatsworth, Calif). Paired t test and linear regression were used to compare the characteristics of the impacted and contralateral teeth. RESULTS: Contralateral and impacted central incisors showed statistically significant differences for root length (95% confidence interval [CI], 2.32-3.46; P <0.001), mesiodistal crown-root angulation (95% CI, 4.09-15.95; P = 0.001), and labiolingual crown-root angulation (95% CI, -18.69 to -4.70; P = 0.002). Etiologic factors did not alter the dimensions of incisors (95% CI, -1.17 to 0.76; P = 0.672). According to the multiple linear regression the independent variables associated with root length of contralateral and impacted incisors were sex (ß = -0.904; 95% CI, -1.62 to - 0.19; P = 0.014) and the presence of impaction (ß = -2.87; 95% CI, -3.67 to -2.07; P <0.001). CONCLUSIONS: Regardless of their etiology, the impacted incisors showed roots that were 2.89 mm shorter than the contralateral incisors and had greater angulation in the mesiodistal and labiolingual directions. Girls showed a reduction of 0.904 mm (7.6%) on the lengths of roots of both impacted and contralateral central incisors. The presence of impaction led to a reduction of 25% in incisor root lengths. Approximately 30% of the impacted teeth showed crown-root angulations >20° resulting in an increased distal and labial angulation of the root apical portion.

Disinfection of Orthodontic Elastomers and Its Effects on Tensile Strength.

OBJECTIVE: This study aimed to investigate the effect of different disinfection protocols on the mechanical properties of orthodontic elastomeric ligatures (EL), an important issue to biosafety improvement and infection control, and to avoid cross-contamination. METHODS: A total of 120 EL were randomly divided into 6 experimental groups (n = 20) according to the disinfection method employed: group 1, EL were not immersed in a disinfectant solution (control group); group 2, EL were immersed in 2% glutaraldehyde; group 3, EL were immersed in 70% alcohol solution; group 4, EL were cleaned in an ultrasound washing (UW) machine by immersion in 0.5% enzyme detergent solution; group 5, UW procedure was performed, followed by immersion in 2% glutaraldehyde; Group 6, UW procedure was performed, followed by immersion in 70% alcohol. After disinfection, EL were subjected to a tensile strength test where the maximum strength, maximum elongation, and work at failure were determined. Data were statistically evaluated using one-way ANOVA and Dunnett's t-test for multiple comparisons. RESULTS: Statistically significant different (P < .05) values were found between the disinfection methods, and 70% alcohol showed negative changes in all mechanical properties of orthodontic elastomers. By contrast, 2% glutaraldehyde did not show significant alteration in mechanical properties, whereas the UW procedure showed significant alteration in maximum strength and work at failure. CONCLUSION: Of the tested substances for disinfection, 2% glutaraldehyde was the only substance that did not cause significant changes in the mechanical properties of orthodontic elastics and is considered as an alternative for elastic disinfection before its use.

Cone-beam computed tomography evaluation of bone plate and root length after maxillary expansion using tooth-borne and tooth-tissue-borne banded expanders.

INTRODUCTION: The objective of this research was to evaluate the buccal bone plate and root length of maxillary permanent first molars using cone-beam computed tomography after maxillary expansion with different activation protocols. METHODS: Cone-beam computed tomography images of growing patients were obtained from the orthodontic department of Pontifical Catholic University of Rio Grande do Sul in Brazil. The groups were Haas-type 2/4 turns, Haas-type 4/4 turns, hyrax-type 2/4 turns, and hyrax-type with alternate rapid maxillary expansions and constrictions (alt-RAMEC) 4/4 turns a day. Tooth length, periodontal insertion, alveolar bone thickness, and intermolar distances were evaluated. The data at the start of treatment and 6 months later were compared using generalized linear models. The intergroup differences were determined by univariate analysis of variance with the Bonferroni adjustment. RESULTS: Tooth length was significantly shortened after expansion in all groups (-0.28 to -0.51 mm), except for the alt-RAMEC group. Bone level variables (bone level and bone level at the tooth tip) changed statistically in all groups, except for the Haas 4/4 turns group. There was significant periodontal attachment loss after rapid maxillary expansion with the hyrax/alt-RAMEC (5.09 mm). The hyrax/alt-RAMEC and hyrax groups had more dehiscences, fenestrations, and exposures of the root. CONCLUSIONS: The consequence of rapid maxillary expansion using the hyrax was alveolar bone resorption, especially in the hyrax/alt-RAMEC group, whereas the Haas expander caused mild root resorption.

Prediction of lower permanent canine and premolars width by correlation methods.

The aim of this study was to determine linear regression equations to estimate the widths of unerupted lower permanent canines and premolars using measurements obtained from 45 degrees oblique teleradiographs. The sample consisted of 30 white Caucasian patients orthodontically treated at the Faculty of Dentistry, Universidade Federal do Rio de Janeiro. The records for each patient included a 45 degrees oblique teleradiograph (left side) in the mixed dentition period and a dental cast of the permanent dentition. Pearson's test was applied between each lower canine, first and second premolars measured on the radiograph, and the sum of their actual widths measured on the dental cast. The strongest correlation occurred for the first premolars for one side (.82) and both sides (.84). One linear regression equation was determined to estimate the widths of un-erupted lower canine and premolars of both sides from a single measurement of the first premolar.